Flywheel gap??? | Arborist, Chainsaw & Tree Work Forum
Rotate the flywheel and remove the business card. Give the flywheel at least one full rotation to make sure there is no contact with the coil and you have a slight visible gap when the
stihl 064 with 066 flywheel coil | Arborist, Chainsaw & Tree Work Forum
Member @L34 adapted "universal coil" to mount on early 064 cases that use Bosch/"dogleg coil", 1122 400 1201A flywheel. Don''t have link to thread, pic shows early 064 case
What are the benefits of a lightweight flywheel and why aren''t they
This previous question explains what a flywheel does and why it is needed. That explanation means that the flywheel needs a certain amount of mass to do its job. However, an
Flywheel removal made easy
The flywheel in the pic looks like the "new" stihl type. 341/361? The correct tool uses the two threaded holes either side of the flywheel nut. Part number 5910 890 4504 for;
Stihl 064 Flywheel and coil issues
Or, mark the keyway of the crank and line the flywheel as you put it on with that mark and fit the flywheel without the key, they are only there to line up the timing, not hold the flywheel on-
Has Anyone Ever Seen a Bad Flywheel Cause No Spark?
The darn thing has no spark. I figured a bad coil, but much to my surprise, if I swapped a different flywheel in, the saw had spark. The flywheel has a broken fin that did some damage to the
064 / 066 / MS660 18 flywheels, 7 coils
QUESTION - I have a flywheel 1203/1204 with a single keyway, when I line up the magnets with a dual keyway 1203 flywheel the single keyway lines up with the 1:00 keyway rather
Tightening flywheel nut on Stihl ms170
Flywheel nuts are most commonly left hand thread. Lets say a saw did have a right hand thread nut,then the same scenario would be true, as soon as that flywheel even slightly loosens the
What does a flywheel do and what is it connected to?
A flywheel serves four main purposes (in most vehicles): It provides mass for rotational inertia to keep the engine in motion It is specifically weighted to provide balance for the crankshaft It